|
Farmall & IHC Tractors Discussion Board |
Re: 315
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on August 17, 2006 at 22:14:07 from (68.115.99.184):
In Reply to: 315 posted by bm3501466 on August 17, 2006 at 20:14:45:
460 Gas had the C-221, 560 Gas had the C-263. Those two engines, and also the C-291 and C-301, share the same basic block design. If I remember right, the 315 combine had the C-221. I think the very early 315"s might have even had the BD-220 truck engine, which the tractor six-cylinder gas engines were based off of. Yes, the six-cylinder gassers will bolt up to the M clutch housing. I have seen a few installed in M"s, they look very neat if a good job of lengthening the frame rails is done. With a little work and money, just about any IH tractor engine will go into an M, even a DT-466. That would tear up the rear end in short order if it was put in the feild.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|