|
Farmall & IHC Tractors Discussion Board |
Re: how to connect cultivator to a 200
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy in NE on August 15, 2006 at 14:55:19 from (204.124.193.164):
In Reply to: how to connect cultivator to a 200 posted by three_deer on August 15, 2006 at 14:30:55:
It sounds like you may have the rear mounted gang for the cultivator. That would bolt to the axle brackets and then have a lifting rod that would pass up along the seat and connect to the rockshaft on the hydraulic unit. It probably passes on the clutch side to that it can be operated independently of the front mounted cultivator. I'm not sure if the 200 mounts the same as the C but the C has three 3/4" tapered bolts right above the front wheels. Then they have lifting rods that connect to the rockshafts. Pretty easy to install.
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
