Farmall & IHC Tractors Discussion Board |
Re: M Family Lineage
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on August 14, 2006 at 08:08:44 from (64.80.110.33):
In Reply to: M Family Lineage posted by City-Boy McCoy on August 14, 2006 at 07:21:26:
Very little changed from the 400 to the 450. It"s still very much an M with stuff bolted on to it. The next step in the lineage would be the 560. While the 560 does have a 6-cylinder engine and an internal hydraulic system, and several areas of the tractor were beefed up, it"s still very much an M in its basic design. The transmission gears, while not the same ratios, will interchange between an M and 560. The frames are the same width, so the rear end of an M could be bolted to the front end of a 560 and vice versa. Beyond the 560 are the 656, 666, and 686. I"ve heard that the 656, 666, and 686 are more H than M, though...
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|