|
Farmall & IHC Tractors Discussion Board |
Re: 47 H: How do you get the Steering Wheel off?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BillyinStoughton on August 08, 2006 at 13:27:52 from (69.214.162.13):
In Reply to: Re: 47 H: How do you get the Steering Wheel off? posted by Mike CA on August 08, 2006 at 13:01:00:
I'd have to say "yes" to the three jaw puller. They are very handy when working on older equipment just for the fact that alot of what you plan to take apart, has been together for over 50 years. They are relatively inexpensive and can save you lots of skinned knuckles and hammering. This is great Mike, as most of the guys / girls on this great site will tell you...with every new project...the toolbox will grow. And yours will too. Good luck with the new find. Everyone will get ya through it. Billy
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|