Farmall & IHC Tractors Discussion Board |
Re: where is he?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on August 04, 2006 at 15:46:21 from (216.208.58.102):
In Reply to: where is he? posted by Rich Iowa on August 02, 2006 at 19:24:58:
Rich: While I must agree with the Vet and gene, yes I was here up until about 9 pm EST on Aug 2nd. However shortly after that I did disappear. We had a vicious electrical storm here, and I think it attacked my modem. I just got the computer back from repair about 3 hours ago, and I'm a $100. poorer. I also must question your judgement, I was a farmer, I did learn a fair bit about the tractors I farmed with, a few statistics on others. Even at that I sit back and hear guys asking about problems on 56, 66 and 86 series Farmalls that hadn't yet happened in the 1980s. Those tractors are a lot older today. So am I, but older and wise enough, I don't want to know anymore about 56, 66 or 86 series tractors.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|