|
Farmall & IHC Tractors Discussion Board |
Re: Letter series axel length?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Andy Martin on July 25, 2006 at 06:02:58 from (64.219.39.195):
In Reply to: Re: Letter series axel length? posted by Mike CA on July 24, 2006 at 15:58:31:
Bumpiness of the tires? They are smooth and sweet. I was only partly kidding. Roading a tractor is great fun, and like Hugh, I've spent many ten hour days on a tractor. For a long road trip the main thing is wind and bugs in your face, and exhaust when the wind is just right. And it takes a lot of time. And your arms get tired. They ride pretty smooth on good roads and really rough on bad roads. It is dangerous. You have to have your wits about you and pay attention at all times to traffic conditions, road conditions, and your inability to stop quickly. However, the view is GREAT and you really do see things you never will from a car or truck because you are going slowly enough to really see. You'll also meet lot's of nice people and lot's of idiots who don't have time to wait tow minutes to pass you. All that said, I would never start on a long trip on a tractor I had not run for several hours and know the condition of the steering, brakes, oil consumption, and knew for sure the rust ahd been shaken out of the fuel tank.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|