|
Farmall & IHC Tractors Discussion Board |
Re: When restoring, what should be the goal?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron in Nebr on July 20, 2006 at 23:58:24 from (66.252.113.39):
In Reply to: Re: When restoring, what should be the goal? posted by Paul Shuler on July 20, 2006 at 17:51:40:
I agree with you 100% Paul. You can find dozens of "factory correct" tractors with perfect paint looking like they're fresh from the factory, and there's countless pictures of them available in books and on the net. What I personally find really INTERESTING is to look at a tractor that's still in it's work clothes with all the owner-applied "modifications and upgrades", no matter how crude, that have been done to it over the years. Wondering what that torch-cut bracket was inteded for or just what was going on when the owner added whatever is really interesting to me and gives a tractor a "personality" all it's own in my mind. I have an F-14 with an old narrowed car straight-axle "wide front end" under it, complete with "Buick" dust caps on the front hubs. The axle setup would no doubt go in the scrap pile if any collector bought the tractor to restore, but it's still neat to look at how they did it. Kind like in the old-car hobby with the musclecars. For years they all made a big stink about cars having to be all original, right down to the "correct" hoseclamps and factory chalk marks on the firewall. These days though there's a swing towards what they call "restification", which is basically a car restored to the condition that it would be in AFTER the original owner put his own personal touches on it back in the day(mag wheels, aftermarket guages, headers, etc). All boils down to just what everyone else has said- it's YOUR tractor, do it how YOU like, and heck with anyone else.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|