|
Farmall & IHC Tractors Discussion Board |
International 350 head gasket??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jeff in Cincinnati on July 10, 2006 at 13:25:10 from (63.250.143.9):
My 350 Utility has always run great, that is until yesterday. As soon as I started it I noticed the radiator acting like it was overheating. It was blowing water out the overflow. . Then is started blowing white smoke out the stack for about 10 seconds. Then it cleared up and ran fine. After about 10 minutes I shut it down. Then it almost immediately started making gurgling sounds and it literally started blowing water/steam out the exhaust. The carburator started dripping antifreeze also and when I pulled the rubber hose off of it antifreeze poured out of the carburator. Right now it won't turn over. It just clicks like it wants to turn over but can't. Anyhow I think I am describing what I hope is a blown head gasket. I think once I pull the spark plugs out I will find a cylinder filled with antifreeze and it will then turn over freely. It was running excellent until I shut it off. Has anyone else had this happen to them? Does it sound like a blown head gasket? Next weekend I plan on tearing into it and finding out the problem. I just hope it is only a head gasket. The darn thing was running great Jeff
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|