Re: piston diminsions

Posted by Janicholson on July 10, 2006 at 06:47:51 from (199.17.6.122):

In Reply to: piston diminsions posted by bland on July 10, 2006 at 06:29:38:

Ryan the book will be no help, nor will telling you do any good. The individual sizes of the pistons in one batch need to be measured. The bore needs to be honed to accommodate that piston alone. Sunnen brand straight hones are the answer. (or similar high quality parallel stone hone. Following the guidance of the hone instructions, and putting hatchmarks on the cylinder of an angle between 40 and 50 degrees, by proper stroking speed is essential. A good micrometer and measuring techniques is mandatory, as is a bore mic, and technique for its use. Feeler gauge techniques can also be used with success. JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]