Farmall & IHC Tractors Discussion Board |
Re: ADDING POWER STEERING TO A 504??????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sloroll on July 06, 2006 at 15:56:02 from (69.66.79.96):
In Reply to: ADDING POWER STEERING TO A 504?????? posted by Ponchobro on July 06, 2006 at 12:50:43:
I did it by purchasing the power steering assy off of a junk 504. You need to add the oil cooler and make sure you get the propper splined shaft coming out of the steering pump under the dash. I found they don't interchange. The pump will need to be added to the rear of the existing hydrolic pump too. The return may have to be drilled and tapped under the seat. It is not difficult (I did it and I spend life in a pretty stupid condition). I recommend a propper parts book and IH maintenence manual. Jeff Forman of IN was a big help to me. He knows his 504s and geerally has parts.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|