Farmall & IHC Tractors Discussion Board |
Equipment Drive Belt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don Mountain on July 05, 2006 at 05:53:06 from (206.72.59.206):
I have a small, antique, International Harvestor belt drive hammer mill that I am wanting to grind corn and oats with for my wife"s horses and chickens. Through help from some folks on this site I acquired a right angle belt drive unit for my old Farmall Super C tractor, and have it mounted and running. Now I am looking for one of the drive belts that are about 5 inches or 6 inches wide, and maybe 8 or 10 feet long to run the hammer mill. I haven"t seen any on eBay for awhile. Are these available new anywhere? Or does anybody have an idea where I can get a good used one? I haven"t seen any listed in the local farm auctions here in Southwest Iowa either. Don Mountain
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|