|
Farmall & IHC Tractors Discussion Board |
Farmall H governor need some advice..
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by River Bottom Farmer on June 29, 2006 at 19:26:31 from (64.12.116.65):
Howdy fellers,I have developed a leak out of the throttle shaft between the block and governor housing.I have an extra governor off another engine and wanted to go through it and swap them out so I can keep using my H for all my chores.I know its not supposed to be to complex of a repair but can someone tell me where I can get a seal for the throttle cross shaft.I wanted to get an idea of where to start and also about the cost of the repair.I would just swap them out but I want to be sure I have no leaks.Also can an outer axle seal be purchased at NAPA or other automotive sources,got the last seals at CIH dealer and it cost nearly forty dollars thought that was sorta steep....RBF
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
