Farmall & IHC Tractors Discussion Board |
Re: Stan from VA farmall 230 engine??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by T.r.y. on June 21, 2006 at 03:13:37 from (205.238.248.178):
In Reply to: Re: Stan from VA farmall 230 engine?? posted by Stan(VA). on June 20, 2006 at 14:21:33:
Hi stan I looked at the pictures and none of those pistons even look similar. The sleeves are wore .006 total. with a taper of .003 So I'm going to just replace. Whats the part number of the 3 1/4 tiscos in your picture that will work with my engine?? We took some putty and reasymbled head and valves and rockers. we put the putty on the highest spot on the piston and turned over by hand tore back down and measured all clearances and we had .319 between the valve and the top of the piston at the closest point. ANy thanks for all the help. I'm trying to learn as much as I can through the process. takcare
Replies:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|