Farmall & IHC Tractors Discussion Board |
Re: Super M Carb
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by newpuller on June 19, 2006 at 15:37:20 from (138.163.0.42):
In Reply to: Super M Carb posted by Tom O on June 19, 2006 at 08:08:10:
I just rebuilt the carb on my M and I found some clogged ports that went inside the venturi. I found them accidentally becasue I took my venturi out and saw that it had junk in it. My tractor hasn't ran yet, it's close to being complete now. If there is a clog in there you might not find it right away. These ports feed a tiny port that sprays gas into the up draft tube in the throttle body above the venturi. It might be worth a look.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|