|
Farmall & IHC Tractors Discussion Board |
E4A Magneto Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lynn Mouser on June 03, 2006 at 07:56:01 from (205.240.133.177):
In the E4A magneto, the ungrounded secondary winding connection is inserted into a hollow post in the collector ring. In my limited experience, I can't tell if there is any retention mechanism to hold the wire in place and/or maintain electrical contact, or if the stiffness of the wire and the depth of insertion into the post are relied upon for continued operation.
The IH Magneto Service Manual ( GSS-5035 ) and Neil Yerigan's How to Restore Tractor Magnetos didn't seem to address this matter, so I'm hoping you folks can shed some light.
Thanks in advance !
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
