Farmall & IHC Tractors Discussion Board |
Re: 6V Charging System on 350U
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on May 27, 2006 at 18:35:32 from (66.244.90.5):
In Reply to: Re: 6V Charging System on 350U posted by MACE on May 27, 2006 at 12:30:07:
Mace, I doubt you can tell with an ohmmeter. My best guess is a 12 volt may have more total field winding resistance but the armature is so low resistance I doubt you can tell much with an ohmmeter. Ive also heard of the black n red tag to tell if 6 or 12 volt but cant say fer sure. The 6 volt has closed spaced commutator bars but again, its hard to tell over the net or unless you have 2 units side by side. Ive used 6 volt gennys to charge 12 by simply using a 12 volt VR, its NOT the best or engineering correct, but it works to some degree. Basically a genny dont know its voltage, its increased by turning it faster or pumping more field current through it which is why a 6 can charge 12 or a 12 charge at 6 in theory. John T
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|