Update Shawn's SC

Posted by Keith-OR on May 27, 2006 at 13:51:00 from (207.200.116.5):

We did the final power wash yesterday, I thought anyway. Finish removing caked on grease and dirt off the oil pan, and surprise, pan has an oil leak. Also lots of dents at the rear of pan. So we removed oil pan, then I could see where someone had did some extensive brassing on it. I removed all dents, now I need to find the leak in the upper part near lip.

One good thing, inside of pan and underside of engine are extremely clean, also had a new gasket. I think Shawn has lucked out on this tractor.

I have some industrial brass epoxy, will it be alright to use it inside the pan after I clean pan with soap and water, then sand it? Thanks

Keith & Shawn

Replies:

• Re: Update Shawn's SC Chris in Washington 08:02:09 05/28/06 (2)
  • Re: Update Shawn's SC Keith-OR 09:59:29 05/28/06 (1)
    • Re: Update Shawn's SC Chris in Washington 12:07:07 05/28/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]