|
Farmall & IHC Tractors Discussion Board |
Another three point question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave in CT on May 24, 2006 at 06:59:52 from (69.177.242.122):
I'm assembling a three point hitch on my H and I think the side links (the two links with the forks at eather end that hang from the lift arms and connect to the side trailing arms) I have may be too long. Would someone send me the length of their side link from fork-pin to fork pin with the link screwed in so it's at its shortest? I'm guessing there's someone out there with a saginaw that's close enough to my design it'll be a good pointer. Thanks for your time.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
