|
Farmall & IHC Tractors Discussion Board |
Re: Farmall A (4 position) switch getting too hot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Cue P. on May 23, 2006 at 09:19:13 from (66.236.176.98):
In Reply to: Farmall A (4 position) switch getting too hot posted by MACE on May 22, 2006 at 17:42:18:
Double check your wiring with the 4 pos switch and voltage regulator. I had the same mistake on my W4. The 4-pos sw is supposed to be used with a cut out relay, not a voltage regulator. Though the two can be used toegther but there was a wire that wasnt supposed to be connected. Sorry i cant remember whihc wire it was. Perhaps Bob M's wiring diagrams can help.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
