Re: trans leaking on 300

Posted by Dave Slater on May 22, 2006 at 18:42:35 from (205.188.116.133):

In Reply to: trans leaking on 300 posted by MoMike on May 22, 2006 at 11:51:04:

The 4 bolts on rear of PTO that use a 3/4 inch wrench to remove is what hold it,but it is sometimes hard to get started out because of tight fit. There's a big O ring that seals it to case. Before removing I would make sure that the seal where the PTO operating shaft passes through PTO case is not the leak.If you remove PTO transmission oil will come out unless front of tractor is a lot lower than rear. The axle seals can be replaced without removing axles.If you have PTO out it would be a good time to check inter axle bearings though.You can see the outside bearings when replacing seals.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]