|
Farmall & IHC Tractors Discussion Board |
Re: cub rear main oil seal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Merlin on April 26, 2006 at 23:27:24 from (209.205.160.9):
In Reply to: cub rear main oil seal posted by william wolfe on April 26, 2006 at 12:57:18:
William, the seals are interchangeable. The problem lies in the seal being an after market and all after markets I"ve seen spins in the seal housing causing it to leak. The standard procedure now is to put your choice of (preferable) hi temp sealer (silicone?) around the outside edge of the seal before installing it it the seal retainer. I say your choice because there has been so much written about this subject and everyone has their own remedy.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|