Farmall & IHC Tractors Discussion Board |
Oil Pressure?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Clunker 340 on April 19, 2006 at 20:42:05 from (69.21.20.31):
I bought a 340 IH at a farm sale. Sounded good, looked good, was supposed to be just overhauled! Thought I bought it reasonable. Loaded it took it home. Started to plow the garden. When the oil pressure, went from 45lbs to 10lbs. At idle it showed about 3 lbs. Water temp 180' Shut it down. Pulled dip stick it is full of clean oil, looks like maybe 30wt. Pulled pan dropped rod and main bearing looked new.very little wear, std. Put it back togather, Same thing happened again? Dose the oil filter cause this prolbem? Is the oil pump shot? Is the valve shot in the pump has new spring in it? has a new bottom plate on it. Oh by the way if you pull the dip stick as soon as it happens the dip stick is on full and is not hot! Any ideas?
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|