|
Farmall & IHC Tractors Discussion Board |
Can't find 1940 M clutch release bearing grease z
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RonFromCT on April 09, 2006 at 19:01:58 from (68.0.250.221):
Well, I've looked and looked and looked. I've read everything anyone on this site has said on the subject, and I'm still lost. The problem is that I can't seem to find the grease zerk for the release bearing that's supposed to be in the clutch housing . There are two holes on the left of the tractor - one (the larger) immediately below the clutch pivot shaft and one (smaller) a few inches toward the rear. When looking and probing into the larger one, I can't see anything that looks like a zerk. The smaller one had cork in it, but removing that just revealed a flat steel face. To make matters more confusing, the parts manual shows the "tube" that is supposed to be for the pilot bearing as the lube point for the release bearing(!?) Some ideas: 1. The bearing was replaced with a sealed bearing? Unlikely, but hey, I'm dyin' here. 2. The zerk backed out and fell to the bottom? There looks to be a point directly inside where there "could" be a zerk, although it's filled with grease. 3. I'm clueless, hopeless, and just plain stupid (very likely), in which case I should just run it till the clutch freezes, drop the belly pump and solve the whole puzzle at that point. If you've already solved this problem and want to be imortalized in my household as a Tractor god, then please let me know how to find this !#$%?@#@* thing. Ron
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|