|
Farmall & IHC Tractors Discussion Board |
Re: IH 444 loader capacity
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by FromJB2 on April 06, 2006 at 17:26:32 from (72.56.121.128):
In Reply to: IH 444 loader capacity posted by wkw on April 05, 2006 at 13:34:22:
Hi Ken in Alberta, to muck out a horse barn easily, make sure the 444 has power steering and hydraulic dump on the bucket and the bucket has tines on it. There were two types of buckets, one type was called a gravel bucket and this is similar to what you see on a industrial front end loader like a CAT loader. The other was an agricultural bucket with tines on it like a fork with an optional "dirt plate" that could be installed over the tines to make it somewhat of industrial type bucket. The problem with this "dirt plate" was that if the tines become slightly bent or twisted is was almost impossible to install or remove the "dirt plate". If your horse manure has lots of straw in it then you will require the bucket with the tines or the manure straw mixture will just roll in front of the bucket. Hope it is an IH 1501 or 1550 loader with hydraulic controls mounted on right side of loader frame. If it is 2250 loader this loader is to heavy for 444, require 584, 684 size tractor. If the rear tires are not loaded with calcium/chloride solution then put some weight on the rear 3pt hitch. Neighbour had made a big cement block for his with a steel rod through it that he just put onto the 3pt hitch when he was doing loader work. Re seat, I have seen replacement seats at TSC. We replaced a seat on the B414 (older model) that we had and all we had to do was frabricate two mounting brackets as the seat is only attach at two places on the casting of the hydraulic reservior. Enjoy JB2
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|