|
Farmall Tractors Discussion Board |
Re: M vs. Super M vs. 400
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Phil Auten on January 13, 2000 at 05:18:33 from (206.175.72.226):
In Reply to: M vs. Super M vs. 400 posted by medfarm on January 12, 2000 at 23:15:39:
Ray,
Besides the sleeves and pistons, you'll need the manifold, carb and a set of governor springs to up the RPM to Super specs. The cam may also be different, but I'm not 100% sure on that. Since you're going that far, why not start with a 264 and build that one up. With the 1/8" over sleeves you get a 281 CID engine as in the 450. The 450 had over 50 HP on the drawbar in stock form. Phil
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
