Re: The shaft is too short

Posted by captaink on April 03, 2006 at 09:04:31 from (66.115.214.56):

In Reply to: The shaft is too short posted by Triker on April 02, 2006 at 17:38:46:

Some steel suppliers or welding/manufacturing shops carry what is called PTO square. If they have it they will carry both the male and the female ends. If you are a competent welder, you can get a longer female tube, or you can lengthen both depending on your situation. The tubes and square shafts are tight fits into the yolks on the ends. Just grind off the existing weld, get the old piece out and put the new longer one in. The new one should fit snug, then just weld it back up being careful to get the amount of welding close to the same on all sides to maintain balance. You will also need to get a longer shield for the PTO.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]