Farmall & IHC Tractors Discussion Board |
Re: farmall c with stuck engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by GaryT on April 02, 2006 at 16:56:40 from (207.69.136.203):
In Reply to: Re: farmall c with stuck engine posted by RegularRog on April 02, 2006 at 15:50:28:
Thanks for the replys,250 is what I offered her,she would take 400,look's like a pass to me.not sure what a rebuild would be iam guessing 1500 or so new rear tires 500 maybe,one rim 100 or so,all this is a guess how close am I? and if you counted labor,I think every one is right cheaper in long run to buy a nice running one.To bad, I'am afraid that C will just sit and rust away, we need to save all the old iron we can but sometimes it's just not possiable.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|