Farmall & IHC Tractors Discussion Board |
Re: Farmall A surges at high throttle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Red Dave on March 28, 2006 at 05:06:07 from (24.104.94.34):
In Reply to: Farmall A surges at high throttle posted by slydog on March 27, 2006 at 19:48:34:
There is a screw on the bottom of the governor that has a cap on it. take the cap off and turn the screw out (if I remember right) to reduce surging. If that doesn't work, try the other direction. Move it one turn at a time and try it, Keep count of your turns so you can go back to where you started if it doesn't work. It's close to the fan, so watch your fingers! I'd adjust it with the engine stopped, then start it and try it out.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|