|
Farmall & IHC Tractors Discussion Board |
Disk size VS horsepower ?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on March 23, 2006 at 21:15:39 from (207.177.83.170):
Hi , I posted this question on Implement alley also so don't distress too much . How do you size a disk to a tractor ? Is there some rule of thumb ? Is it determined by horsepower or weight of tractor ? I guess that there's a number of variables involved . One other question , Is it a foolish notion to try and pull double duty with a disk meaning I have a Farmall M and a 1755 Oliver , about 7000 lbs and 50 hp difference . Question is - if the disk has a main frame width of 14'and unfolded is 20' not including the furrow fillers would the M pull it with the wings up and the 1755D pull it with it unfolded assuming 18"-20" blades ? Thanks ...Randy
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
