Farmall & IHC Tractors Discussion Board |
Re: 706- puddles under the plugs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wayne Swenson on March 08, 2006 at 09:20:42 from (66.228.250.33):
In Reply to: 706- puddles under the plugs posted by IndianaScott on March 08, 2006 at 05:28:24:
Oil in puddles leads me to think that the valve cover gasket is leaking. That amount of oil should not come past the sparkplug threads/gasket unless the cylinder was literally "drowning" in oil. To verify, remove the sparkplugs & THOUROUGHLY clean the gasket seating surface. Dig out all the old gaskets someone else left behind. Use the end of a smaller mill file (it is hard & sharp) to dig & scratch around to get down to bare metal. Find the correct spark plug thread tap & clean the threads in the head; they get carboned up & you think the plug is tightened properly but it is not sealed at the gasket. If you do not have a tap, take an old sparkplug & hacksaw 3-4 grooves at a right angle to the the threads. take the old gasket off & you now have your own tap!
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|