Farmall & IHC Tractors Discussion Board |
Re: Farmall H stability??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on March 06, 2006 at 12:22:34 from (64.179.117.210):
In Reply to: Re: Farmall H stability?? posted by Janicholson on March 06, 2006 at 12:02:03:
Myself i like the track hoe -dozer methiod , i can do a lot of clearing in short order and the worst thing is ya might eat a littel dirt off a root . the dumbest thing i ever did with a tractor was the day that i got a fast hitch blade stuck in the fast hitch of my 450 because we thought that we had to use the spacers as that is what the salesman told me so we installed the spacers and started to shove the prongs into the fast hitch well they stoped going in and my buddy says just back into that tree as they are rusty well we did that and they were only half way in and would not come out SO NOT BEING TO BRIGHT AnD NOT HAVING A HALF WIT BETWEEN THE TWO OF US WE GET HIS 450 AND A BIG CHAIN AND HOOK BOTH TRACTORS BACK TO BACK THE CHAIN TO THE BLADE AND THE CHAIN TO THE OTHER 450 DRAW BAR AND THIS IS A LOOONNNNGGGGG CHAIN PUT BOTH TRACTOR IN ROAD GEAR FULL THROTTEL AND BONZZI , well the blade came out and went WHY UP IN THE AIR and what goes up must come down , now just picture this 8 foot fast hitch blade at the end of a long chain about 25 feet up in the air moving in and arck good thing that there was a couple EXTRA notches on the throttel for more foward speed and a nice long field to TRY and run away from it . after the dust had setteled and everybodys knees stopped shaken we sorta looked at each other and like wooooow that was close.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|