|
Farmall & IHC Tractors Discussion Board |
450D wheel bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill46 on March 01, 2006 at 04:57:01 from (12.36.152.153):
Anyone ever have to replace the inner bearing on a Farmall with the narrow front end.
I raised the tractor up last night to put on new rims and tires and found the inside bearing has a lot of slop in it.
The manual says to grease it with the bearing on the tractor and only remove it if you have to.
Ok...looks like I have to, but how do you get a puller in there? I hate to heat the bearing race and I for sure do not want to try and bust it off. I do not want to ruin the spindle.
Any ideas?
Thanks.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
