|
Farmall & IHC Tractors Discussion Board |
Farmall C Alternator Update
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robert Lorencz on February 27, 2006 at 14:30:18 from (64.12.116.65):
Good day My last post on this subject was that my newly installed alternator decided to pump out about 17 volts continuously so I replaced the alternator with another rebuilt and every thing was cool. I asked a few questions on here about the old alternator and got some good information. So I wanna thank those guys. El Toro - thanks for leading me to the site for regulators. I got the part number, went to NAPA and they got me one for about 8 loonies. Went to your suggested site for replacing it, not too bad, they forgot to tell me about the springs and brushes popping out when I pulled the rotor! Not to worry, installed new regulator, got brushes back in holders and held them with little piece of wire while I assembled the alternator. Bob M - your advice and your wiring diagrams are superb. I have installled a bigger diode and a 10 ohm resistor on the tractor now. Yugrcart - You were bang on about "The Source" here in Canada. I went on line, found them, they had diodes and resistors, I ordered them and they delivered them to my doorstep by Purolator for 2 loonies! So, the end result - after I installed the regulator in the alternator, I tried it out on the C and it works perfectly. Now I have a spare alternator for another tractor - hmmm, am I gonna have to buy something else?!!!!!!!!! Thanks guys!!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|