Re: 340 to 460 compatability

Posted by Hugh MacKay on February 14, 2006 at 14:40:38 from (64.228.11.76):

In Reply to: 340 to 460 compatability posted by greg schnakenberg on February 14, 2006 at 12:33:57:

Greg: Not sure I have your answer. I'm thinking you should be able to split the two tractors at the clutch housing and bolt your 460 front to the 340 rear. But I'm not certain. Why don't you just skip on over to the left of this page, click on shop for parts, then IH, click on clutch assembly. If the same clutch assembly is shown for both that should tell you it's worth checking further. I would then start checking some part numbers, namely the part number for torque tubes for both tractors. If that torque tube-clutch housing and clutch housing is same for both it can be done. You will have to use 460 sheet metal, at least some of it, maybe all.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]