|
Farmall & IHC Tractors Discussion Board |
Hey international Guys need you help on a new piec
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ironhorse on January 29, 2006 at 16:51:14 from (205.188.116.133):
jusr got a International U-240 power unit. It has a Silver diamond Engine. In getting it home several hundred miles. I broke lose every piece of rust in the gas tank. and when i got home to start it to for my wife and neighbors the new engine it didnt go. so pulled the tank and cleand out the clogs. then on to clean the carb. As usual in my hurry to hear it run again forgot how many turn in and out. So what i need is the intial adjustment on this carb and looks like three screws I know one is high speed and one idle speed and i got one on the shaft the goes between the carb and gov. the setup look like whats on the older farmalls. I got it to run but only with the choke out. that for you help and also where to get a manula for this? thanks Ironhorse
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
