|
Farmall & IHC Tractors Discussion Board |
Re: Just tallied up the total on this project...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on January 25, 2006 at 17:51:16 from (204.249.178.138):
In Reply to: Re: Just tallied up the total on this project... posted by scott#2 on January 25, 2006 at 14:18:44:
I did the test pieces. The 58 460 I'm working on actually came from the factory with IH 201 -- My PPG dealer's computer did not show any listing for that, so I settled on a 2150 equivalent. IH began using 2150 in 1961 when the 60 series was still in production. Case-IH 2150 does have an orange tint to it to my eyes, there will be those who say it doesn't. I had the dealer "digitally" photograph the 2150 sprayout, his camera or scanner or whatever PPG calls it did not even get close. So, as you did I juggled the toner ratios. I'm guessing that a 20 gram switch would be better than the 10 I used (my first try), but I looked at my test pieces in full sun, and really could not tell the difference from 2150, depending on how the light hit them -- it will have an orange tint to it, but to my eyes that is normal. It will not be nearly as orange as my last tractor, the mixer simply messed up. A 40 gram switch will be way too red, IMO. Problem is, there aren't any original tractors left, and I simply do not remember how dark the red was, although I drove an H (both original and repainted) for 10 years before I left home. I had a gallon mixed after I used up the pint, there is no difference that I can see -- the dealer was careful to get it the same. I did have one mix from the camera that could not be mixed in the pint size -- It was waaay off -- I have no confidence in the cameras ability to match colors, PPG only says it can do 80%, that really isn't very good. I would like to actually see your tractor, if you were 1000 miles closer.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|