Re: Stud bolts

Posted by Janicholson on January 25, 2006 at 13:09:02 from (199.17.6.175):

In Reply to: Stud bolts posted by Don Brien on January 25, 2006 at 12:49:45:

If the head has been removed to replace the stud, (and I assume not started) I would use copper coat spray on both sides of the "used" gasket and go for it. If it was sealed down the firat time, and came apart with pieces on both head and block, I would not use it. If it was stuck to one side and the other came claen, I would use Copper coat on that side and use it. If the stud was replaced without removing the head, I would just torque the stud, and run it. May it be just fine.
JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]