Distributor timing on Super C

Posted by DFZ on January 23, 2006 at 13:52:26 from (4.242.195.117):

I rescently rebuilt my govenor and put it back in, and just wanted to check if I timed it right. The govenor gear that meshes in with the engine had one little black dot on it. I meshed that with the "O" on the other gear. Below the "O" were some part numbers. (I don't know the inside of a farmall engine. Is that the camshaft or crankshaft or what?)

Also on there was another small mark on the camshaft gear. I don't remember exactly what the second mark looked like. But it was only one small mark without partnumbers next to it.

Do you think I timed it to the right one? It starts up? I guess I could just check and see at TDC does the rotor appear to be in the right place. Thanks for any suggestions.

Replies:

• Re: Distributor timing on Super C Janicholson 09:12:40 01/24/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]