Re: I need a mesuring tool.

Posted by RustyFarmall on January 17, 2006 at 15:53:23 from (207.32.13.204):

In Reply to: I need a mesuring tool. posted by Kelly C on January 17, 2006 at 15:28:20:

Kelly, you need a micrometer. This is a precision measuring instrument, capable of measuring to the .001" of an inch, or even finer increments if you desire. Micrometers are furnished in 0 to 1 inch size, 1 to 2 inch, 2 to 3, etc. These are a very fine and precise measuring instrument, they require a bit of training to use properly and give accurate readings, and also require special care and handling. It's been awhile since I bought one, but a quality mic. in the size you need would run somewhere around $100 I think. Less expensive brands are out there, but I question the quality. E-Bay is full of them, but again, are they good? This might be a good time to take your crankshaft to town and pay a machinist to analyze it.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]