|
Farmall & IHC Tractors Discussion Board |
Here I go again-MCV
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SGT K on January 13, 2006 at 07:32:10 from (216.125.213.242):
I have had trouble with the steering not working on the 1466 after start-up. I asked about this last year and got some good advice, even though I'm ashamed to say some of it was a little over my head. I went through my valve body and put some seals and O-rings in the power steering pump and it got me by another year.
The other day I started it and it would not take prime, no matter how much I messed with it. I thought the flow control valve was stuck, so I took it out and cleaned it up-no help. I took the safety valve assembly out of the bottom, thinking I could bleed off any air-no help. I took them both out and turned the tractor over with the starter-no oil. I started the tractor and it would just sputter a little oil out of the flow control valve every now and then. Shouldn't oil pump out of the flow control valve? I'm ready to put in a rebuilt power steering pump. Can you think of anything my simple mind might be missing???
Thanks,
Paul
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
