|
Farmall & IHC Tractors Discussion Board |
Re: International 560 industrial tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Andy Martin on January 04, 2006 at 11:32:39 from (64.219.39.195):
In Reply to: Re: International 560 industrial tractor posted by BuckyL on January 04, 2006 at 07:34:25:
Sounds like you answered your own question. There are no NADA type ranges to go by. Part of the difficulty is that tractors are sold and resold in a condition which would only be junk in the automobile world. Cars which would not drive 20 miles without overheating, missing tires or wheels, hood or door missing, etc. and no one would think of as selling for transportation are equivalent to tractors selling for $300 to $3,000. If you like it and can afford it, buy it. You recieved some good advice from Nebraska Cowman. He told you he would not try to plow with one. What you should compare it to are other tractors currently available in your market area. It may be the best deal around if you need it. If you are looking to find gold nuggets, that takes lot's of patience, lots of looking, and sometimes they just aren't there. If you're looking for a $2,500 loader tractor which will do a lot of work for you with little or no maintenance you might be better off looking for gold nuggets. In my opinion M Farmalls are about the cheapest horsepower around but they are not loader tractors, are not well designed for three point implements, and are not very suitable for heavy duty hydraulic work. Those features are why they are cheaper than an inferior 9N Ford. You might pay for the loader for the 4100 if you save the gas the 560 will burn. If you just want another tractor, don't try to justify it, just buy it and tell your wife you don't know why you did. It works for the rest of us.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|