|
Farmall & IHC Tractors Discussion Board |
Re: Hydraulic cylinder repair and loader question.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan in NE on January 02, 2006 at 12:18:54 from (148.78.243.26):
In Reply to: Hydraulic cylinder repair and loader question. posted by tfringo on January 02, 2006 at 11:31:22:
Terry, Just my two-cents worth. On the cylinder, I would just very lightly dress it down and throw 'er together. Takes one heck of a gouge to make 'em leak to any substantial amount. If the loader has a tank, it was designed to work via a self-contained system using a PTO pump and completely independent from the tractor. Sounds like you are trying to marry the loader tank to the tractor hydraulics? You’ve got to choose which system you want to use; don’t tie ‘em together. Hope ya get 'er goin' Allan
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
