|
Farmall & IHC Tractors Discussion Board |
47M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BHV Mike on December 29, 2005 at 21:02:02 from (66.58.210.159):
Changed oil in transmission/rearend of my M. When oil drain stream stopped I dug out some sludge and found a ball bearing approximately 3/8th inch in the drain hole. The ball had a moon shaped gouge. What part of the transmission rearend would this be from? Could it be left behind on a previous repair job? Plowed with it after the oil change and no problems. I have owned this tractor for a couple years. Comments?
Replies:
- Re: 47M Janicholson 21:33:53 12/29/05
(0)
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
