|
Farmall & IHC Tractors Discussion Board |
Re: 4166 picture attempt
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by P Backus on December 29, 2005 at 20:28:28 from (69.128.32.197):
In Reply to: Re: 4166 picture attempt posted by Steven@ND on December 29, 2005 at 19:57:44:
Hi Steven, Mine"s a "73. They started out with the 4100 in 1966 at the same time they were developing the 1206. Then in "69 and "70 it became the 4156. Both of those had the DT429 motor in them. In "71 it turned into the 4166 and they put the DT436 in it. Then from "76 through "78 it was the 4186, still with the DT436. Even though all the other IH tractors got a nicer cab and other upgrades with the 86 series, these stayed pretty much the same to the end, even the grill I think. Paint scheme was a little different. I guess the production numbers were too low to justify any big changes. Paul
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|