Re: super a engine bearings

Posted by El Toro on December 29, 2005 at 09:49:33 from (152.163.101.13):

In Reply to: Re: super a engine bearings posted by werowance on December 29, 2005 at 08:27:56:

Most bearing inserts are stamped whether they're
std or undersize. If not std should have .001, .002 & some may have .003 same if the shaft has been ground would have .010 on the insert down to .030". You can use plasti-gage,
it won't tell you if the shaft is egg-shaped. You can use that with a new insert and see how much clearance you have. For a close tolerance you should have a clearance of .001" to .0015".
You can run close tolerances on these engines since they're are pressure lubricated. The engines that have dippers need more clearance. Hal

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]