|
Farmall & IHC Tractors Discussion Board |
B will not start
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JT on December 28, 2005 at 16:15:13 from (70.226.202.54):
I have finally got this thing in time, mechanically. Now the rotor will not line up with #1 to try to time mag to engine. This will only go 2 ways,so it cannot be rocket science. When I try to start it, all it does is explode in the exhaust manifold. I am at my wits end, any advise from anyone???? I am going to get a mag book out and see if mag may be out of time internally. The closest I can get the rotor is just a little past cylinder #2, cannot get it to time to # 1 at all. The engine is at DC on Flywheel, lined up with pointer, so I feel I am at TDC on #1 cylinder when doing all this. Any ides??? Just had front of tractor off to make sure was in time mechanically.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The 9N Lives Again - by Tyler Neff. I often reminisce about the good old days of my youth when I visited my grandparents on their farm in Moorefield, West Virginia. I lived in Middletown, Maryland, which was about two and a half hrs away from the farm. During my summer vacations I would spend two weeks helping granddad Wilmer with his farming duties. Wilmer and his brother Weldon owned the �Neff� farm. Th
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
