|
Farmall & IHC Tractors Discussion Board |
Re: Farmall axle parts source needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by farmallhal on December 10, 2005 at 06:08:18 from (64.24.35.16):
In Reply to: Farmall axle parts source needed posted by 3/4 ton on December 10, 2005 at 04:15:14:
Might try Carter & Gruenewald in Wisconsin-phone 1-866-FARMALL (327-6255). Have seen lots of good comments above their knowledge and service. Brumuda Ken might see this post and post a response. If the front end is by someone other then IH you will probably need to try and contact the original maker. Good luck, Hal
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
