Farmall & IHC Tractors Discussion Board |
Re: the downfall of IH
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dave from MN on December 02, 2005 at 06:58:19 from (67.2.202.90):
In Reply to: Re: the downfall of IH posted by NDS on December 02, 2005 at 06:29:54:
NDS, There is not anything wrong for making a $20.00/ hour as an assemly technician, if the business they work for can afford it and make more than at least a 4% profit margin, less than that and the investor may as well put the millions in a CD. What the problem is when there are 1400 people making $20/ hour the work can be done with 1000 people but due to poor work ethics, lack of pride in work, and what ever reasons the other 400 are there making the same cash sitting on their butt. In some , not all, factorie a pay for performance scale would eliminate the "slackers" which cost manufacturers millions, and reward the (wanted and needed and irreplacable) employees with probabaly a better rate and benifit package than the get by the union contract book. If you hired 3 people and after 30 days you had to pay them all the same regardless of there attendance, quality, actions, or performance, would you want to be bound like that? Yes higher wages are good sometimes, but after 30 years of increases anything made in the US cost more, everything we buy cheap ( so we can spend more on that new truck to show every one we have good wages) is made in another country, soon so will that truck. Heck steel prices are nutts, how much of that steel is from the US? Some day all this cheap stuff will be high priced also, and many of us will not be making a good income cause there will be very jobs that you can make a living at. Do I run to walmart to buy a freezer made in china so I can save $20? Heck no I will buy one that is made in St. Cloud MN and pay what I need to , because if I dont, I will be part of the issue of putting freinds and neighbors out of a job.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|