|
Farmall & IHC Tractors Discussion Board |
Re: F. Cub info needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by R-cubed on December 01, 2005 at 21:20:10 from (70.130.232.105):
In Reply to: F. Cub info needed posted by JJ in B.C. on December 01, 2005 at 18:03:22:
There were two models the tall one (row crop) and the Lowboy. They were basically the same except the final drive was rotated 90 degrees on the lowboy thus reducing it's height by about 10 inches. The tall ones turn over rather easy so watch it when leaning to the left. They say they are worth $1500+ but nobody has been trying to beat me out of mine. I need to trade it for an A because it doesn't have enough power to pull the slack out of my suspenders.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|