|
Farmall & IHC Tractors Discussion Board |
O.T. Ford Ranger
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Buzz on December 01, 2005 at 14:20:59 from (65.143.128.32):
Hey there, I know this hain't a tractor question.....bare with me. Got a 1987 Ford Ranger with a 4 cylinder 2.3 engine that has a bad oil leak. Is leaking between the engine and tranny---leaks out on top of tranny, drivers side. I thought maybe there was an oil passage plug between the engine and tranny, so I pulled the tranny and all plugs are tight. SHOOT!! Main seal is good. Oil sending unit is good. Valve cover is good. Only thing I can think of is a head gasket cause that would leak right on that area. Any ideas on this? Never thought of a head gasket leaking so much externally. Has overhead cam and the rear plug looks good on that too. Oh yea, it is painted red. Thanks, Buzz
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
